Instruction manual

Guppy PRO Technical ManualV4.1.0

215

Configuration of the camera

The time base IDs 0-9 are in bit [28] to [31]. See Table 132 : Time base ID on page

215. Refer to the following table for code.

Default time base is 20 μs: This means that the integration time can be changed

in 20 μs increments with the shutter control.

The ExpOffset field specifies the camera specific exposure time offset in micro-

seconds (μs). This time (which should be equivalent to table 65:) has to be

added to the exposure time (set by any shutter register) to compute the real

exposure time.

The ExpOffset field might be zero for some cameras: this has to be assumed as

an unknown exposure time offset (according to former software versions).

0xF1000208 TIMEBASE Presence_Inq [0] Indicates presence of this fea-

ture (read only)

--- [1..7] Reserved

ExpOffset [8..19] Exposure offset in μs

--- [20..27] Reserved

Timebase_ID [28..31] See Table 132 : Time base ID

on page 215.

Table 131: Advanced register: Time base

Note



Time base can only be changed when the camera is in idle state

and becomes active only after setting the shutter value.

ID Time base in μs

310

4 20 Default value

550

6100

7200

8500

91000

Table 132: Time base ID