Instruction manual

Guppy PRO Technical ManualV4.1.0

221

Configuration of the camera

Input/output pin control

Delayed Integration Enable (IntEna)

A delay time between initiating exposure on the sensor and the activation edge

of the IntEna signal can be set using this register. The on/off flag activates/

deactivates integration delay. The time can be set in μs in DelayTime.

0xF100029C DPC_MEM Presence_Inq [0] Indicates presence of this feature (read only)

--- [1] Reserved

EnaMemWR [2] Enable write access from host to RAM

EnaMemRD [3] Enable read access from RAM to host

DPDataSize [4..17] Size of defect pixel data to read from RAM to host.

A maximum of 2000 defect pixels can be stored. To get

the number of defect pixels read out this value and

divide by 4.

In case of more than 2000 defect pixels, DPDataSize

is set to 2001 pixels

(DPDatasize of 8004 divided by 4 equals 2001 pixels)

and BuildError flag is set to 1.

Defect pixel correction data is done with first 2000

defect pixels only.

AddrOffset [18..31] Address offset to selected defect pixel data

0xF10002A0 DPC_INFO Presence_Inq [0] Indicates presence of this feature (read only)

--- [1..3] Reserved

MinThreshold [4..10] Minimum value for threshold

MaxThreshold [11..17] Maximum value for threshold

MaxSize [18..31] Maximum size of defect pixel data

Note



• See chapter Input/output pin control on page 67

• See chapter IO_INP_CTRL 1 on page 67

• See chapter IO_OUTP_CTRL 1-3 on page 71

• See chapter Output modes on page 72

Table 136: Advanced register: Defect pixel correction