Instruction manual

Guppy PRO Technical ManualV4.1.0
65
Camera interfaces
Error conditions
Blink codes are used to signal warnings or error states (When S1 and S2 blink
together, you see blinking orange):
• S1 means green half of LED
• S2 means red half of LED
• Example: LLC not ready  S1 (3 blinks) + S2 (5 blinks): 3 orange blinks and
afterwards 2 red blinks
Video mode error: These are error modes according IIDC specification:
Vmode_Error_Status register (wrong settings of video mode, format, frame rate
and ISO settings).
Format 7 error: see Format 7 register description of IIDC specification.
Error Code S1
Error Class S2
1 blink 2 blinks 3 blinks 4 blinks 5 blinks 6 blinks 7 blinks
1 blink Video
mode
error
Format 7
error 1
Format 7
error 2
2 blinks Camera
class
object
Camera
regconst
object
Register
mapping
Unknown
FPGA type
ID
3 blinks FLASH
class
object
Platform
class
object
Platform
initializa-
tion
Platform
firmware
set
Platform
LLC
version
4 blinks FPGA boot
S1 error
FPGA boot
S2 error
FPGA boot
S3 error
FPGA boot
S4 error
FPGA boot
S5 error
FPGA ver-
sion not
supported
5 blinks Stack
setup
error
Stack
start error
LLC not
ready
6 blinks
7 blinks
8 blinks No valid
firmware
set
available
Table 23: Error codes