Specifications

GX1050 Technical Manual

Page 12

EXTERNAL POWER

This connection provides the main power for the camera. The camera operates from a

DC voltage between 5V to 24V. The current capacity of the power supply can be

estimated by dividing the camera’s power requirement by the external power voltage. It

is also recommended to factor this by about 50% as follows:

Power supply current capacity = (power specification / external voltage) x 1.5

The conductor used for this connection must be adequate for the current consumption

of the camera. For best performance the connection for EXTERNAL POWER should be

physically close to the POWER GROUND connection.

SYNC INPUTS (1 and 2)

The input signals allow the camera to be synchronized to some external event. These

signals are optically isolated and require the signal common (USER GROUND). The

camera can be programmed to trigger on the rising or falling edge of these signals. The

camera can also be programmed to capture an image at some programmable delay

time after the trigger event. These signals can be driven from 5V to 24V with a current

load of 5mA.

VDD+3.3

180R

1/10W

5V TO 24V

IF = 5mA

5V TO 24V

IF = 5mA

PIN 4. SYNC IN 1

180R

1/10W

TO CAMERA

LOGIC

PIN 11. SYNC IN 2

PIN 7. USER GND

MMBF4393LT1G

VCC

GND

HCPL-063L