Instruction Manual

Mako Technical Manual V2.0.4

Specifications

Mako G-032B/C

Caution



Before operating any AVT camera, read the safety instructions

and ESD warnings in the AVT GigE Installation Guide.

http://www.alliedvisiontec.com/emea/support/downloads/

product-literature/hardware-installation-guide.html

Caution



Due to the small packaging and high speed of Mako cameras,

take special care to ensure that the housing temperature of

the camera does not exceed 50 °C. Following are general

guidelines for heat dissipation:

• Mount the camera on a heat sink such as a metal bracket.

• Lenses, when attached to a camera, act as a heat-sink and

help reduce housing temperature.

• Ensure sufficient air flow. Use a fan if necessary.

Feature Specification

Sensor Type 1/3 (diag. 6 mm) progressive scan SONY IT CCD ICX424AL/AQ with

HAD microlens

Effective chip size 4.9 mm x 3.6 mm

Cell size 7.4 µm x 7.4 µm

Resolution (maximum) 658 x 492 pixels

Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)

Maximum protrusion: 9.8 mm (see figure 18)

CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)

Maximum protrusion: 4.8 mm (see figure 20)

ADC 14 bits

Pixel format Only monochrome: Mono8, Mono12Packed, Mono12

Only color: BayerRG8, BayerRG12, BayerRG12Packed, Mono8,

RGB8Packed, YUV411Packed, YUV422Packet, YUV444Packed,

BGR8Packed

Frame rates Up to 102 fps

Gain control Manual: 0–30 dB (1 dB/step); auto gain (select. ROI)

Exposure time 10 µs to 93 s; auto shutter (select. ROI)

Table 3: Specification Mako G-032B/C

Note



Maximum protrusion means the distance from lens flange to

the glass filter in the camera.