Instruction Manual

Mako Technical Manual V2.0.4

Specifications

Mako G-125B/C

Feature Specification

Sensor Type 1/3 (diag. 6 mm) progressive scan SONY IT CCD ICX445ALA/AQA

with EXview HAD microlens

Effective chip size 4.8 mm x 3.6 mm

Cell size 3.75 µm x 3.75 µm

Resolution (maximum) 1292 x 964 pixels

Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)

Maximum protrusion: 9.8 mm (see figure 18)

CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)

Maximum protrusion: 4.8 mm (see figure 20)

ADC 14 bits

Pixel format Only monochrome: Mono8, Mono12Packed, Mono12

Only color: BayerRG8, BayerRG12, BayerRG12Packed, Mono8,

RGB8Packed, YUV411Packed, YUV422Packet, YUV444Packed,

BGR8Packed

Frame rates Up to 30 fps

Gain control Manual: 0–30 dB (1 dB/step); auto gain (select. ROI)

Exposure time 12 µs to 84 s; auto shutter (select. ROI)

External trigger event Rising edge, falling edge, any edge, level high, level low

External trigger delay 0 to 42 s in 1 µs increments

Fixed rate control 0.012 fps to maximum frame rate (steps of 0.001 fps)

Imaging modes Free-running, external trigger, fixed rate, software trigger

Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO

Internal image memory 64 MByte, up to 52 frames

Smart functions Auto gain control, auto exposure control, 64 MByte image memory,

binning (monochrome binning, also for color cameras; but no color

binning), LUT, gamma, config files (user sets)

Only color: auto white balance, hue, saturation

I/O One configurable optocoupled input

Three configurable optocoupled outputs

Table 4: Specification Mako G-125B/C

Note



Maximum protrusion means the distance from lens flange to

the glass filter in the camera.

Note



The number of frames (StreamHoldCapacity) depends on

resolution, pixel format, and GVSP packet size. Stated number of

frames is typical for full resolution, Mono8/Bayer8, and

GevSCPSPacketSize = 8192.