Instruction Manual

Mako Technical Manual V2.0.4
20
Specifications
Mako G-223B/C (NIR)
Feature Specification
Sensor Type 2/3 (diag. 8 mm, 1 inch lens recommended) CMOS sensor: CMOSIS
CMV2000 (monochrome/color) with microlenses and global shutter
The monochrome version is also available as NIR enhanced variant
(Mako G-223B NIR). Except for the sensor response, the technical
data of the NIR enhanced variant are identical with Mako G-223B.
Effective chip size 11.26 mm x 5.98 mm
Cell size 5.5 µm x 5.5 µm
Resolution (maximum) 2048 x 1088 pixels
Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 10.8 mm (see figure 19)
CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 5.8 mm (see figure 21)
ADC 12 bits
Pixel format Only monochrome: Mono8, Mono12Packed, Mono12
Only color: BayerGB8, BayerGB12, BayerGB12Packed, Mono8,
RGB8Packed, BGR8Packed, RGBA8Packed, BGRA8Packed,
YUV411Packed, YUV422Packet, YUV444Packed
Frame rates Up to 49.5 fps
Gain control Manual: 0–26 dB (1 dB/step); auto gain (select. ROI)
Exposure time 21 µs to 153 s; auto shutter (select. ROI)
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 306 s in 1 µs increments
Fixed rate control 0.01 fps to 49.52 fps (steps of 0.1 fps)
Imaging modes Free-running, external trigger, fixed rate, software trigger
Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO
Internal image memory 64 MByte, up to 29 frames
Smart functions Auto gain control, auto exposure control, 64MByte image memory,
no binning, LUT, gamma, config files (user sets)
Only color: auto white balance, hue, saturation
Table 5: Specification Mako G-223B/C
Note

Maximum protrusion means the distance from lens flange to
the glass filter in the camera.
Note

The number of frames (StreamHoldCapacity) depends on
resolution, pixel format, and GVSP packet size. Stated number of
frames is typical for full resolution, Mono8/Bayer8, and
GevSCPSPacketSize = 8192.