User Manual

Manta Technical Manual V7.0.1
32
Specifications
Manta G-095B/C
Feature Specification
Sensor Type 1/3 (diag. 6 mm) progressive scan SONY IT CCD ICX692AL/AQ with
EXview HAD CCD II microlens
Effective chip size 6.04 mm x 4.0 mm
Cell size 4.08 µm x 4.08 µm
Resolution (maximum) 1292 x 734 pixels
Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 9.7 mm (see figure 48 on page 86)
CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 5.1 mm (see figure 49 on page 87)
ADC 14 bit
Pixel format Only monochrome: Mono8, Mono12Packed, Mono12
Only color: BayerRG8, BayerRG12Packed, BayerGR12, Mono8,
RGB8Packed, YUV411Packed, YUV422Packet, YUV444Packed,
BGR8Packed, RGBA8Packed, BGRA8Packed
Frame rates Up to 40 fps
Gain control Manual: 0–32 dB (1 dB/step); auto gain (select. ROI)
Exposure time 45 µs to 60 s; auto shutter (select. ROI)
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 60 seconds in 1 µs increments
Fixed rate control 1 fps to maximum frame rate (steps of 0.1 fps)
Imaging modes Free-running, external trigger, fixed rate, software trigger
Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO
Internal image memory 32 MByte, up to 34 frames
Smart functions Auto gain control, auto exposure control, 32 MByte image memory,
binning (monochrome binning, also for color cameras; but no color
binning), no decimation (no sub-sampling), config files (user sets), LUT
only color: auto white balance, color correction, edge filter (sharpness),
hue, saturation
I/O Two configurable optocoupled inputs, two configurable optocoupled
outputs
RS232 port (serial port)
Digital interface IEEE 802.3 1000BASE-T (GigE Vision V1.2)
Camera control interface GenICam V1.0 compliant
Table 7: Specification Manta G-095C
Note

The number of frames (StreamHoldCapacity) depends on resolu-
tion and pixel format. Listed number of frames is typical for full
resolution and Mono8/Bayer8.