User Manual

Manta Technical Manual V7.0.1
38
Specifications
Manta G-145B NIR
Feature Specification
Sensor Type 2/3 (diag. 11 mm) progressive scan SONY IT CCD ICX285AL with
EXview HAD microlens
Effective chip size 9.0 mm x 6.7 mm
Cell size 6.45 µm x 6.45 µm
Resolution (maximum) 1388 x 1038 pixels
Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 9.7 mm (see figure 48 on page 86)
CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 5.1 mm (see figure 49 on page 87)
ADC 14 bit
Pixel format Mono8, Mono12Packed, Mono12
Frame rates Up to 15.04 fps (NIR mode: Off/On_Fast)
Up to 13.98 fps (NIR mode: On_HighQuality)
Gain control Manual: 0–33 dB (1 dB/step); auto gain (select. ROI)
Exposure time 20 µs to 60 s; auto shutter (select. ROI)
28 µs to 60 s for NirMode=Off/On_Fast and ExposureMode=External
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 60 seconds in 1 µs increments
Fixed rate control 1 fps to maximum frame rate (steps of 0.1 fps)
Imaging modes Free-running, external trigger, fixed rate, software trigger
Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO
Internal image memory 32 MByte, up to 22 frames
Smart functions Auto gain control, auto exposure control, 32 MByte image memory,
binning (monochrome binning), decimation (sub-sampling), config
files (user sets), LUT
I/O Two configurable optocoupled inputs, two configurable optocoupled
outputs
RS232 port (serial port)
Digital interface IEEE 802.3 1000BASE-T (GigE Vision V1.2)
Camera control interface GenICam V1.0 compliant
Table 10: Specification Manta G-145B NIR
Note

The number of frames (StreamHoldCapacity) depends on resolu-
tion and pixel format. Listed number of frames is typical for full
resolution and Mono8.