User Manual

Manta Technical Manual V7.0.1

Specifications

Manta G-146B/C

Feature Specification

Sensor Type 1/2 (diag. 8 mm) progressive scan SONY IT CCD ICX267AL/AK with

HAD microlens

Effective chip size 6.5 mm x 4.8 mm

Cell size 4.65 µm x 4.65 µm

Resolution (maximum) 1388 x 1038 pixels

Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)

Maximum protrusion: 9.7 mm (see figure 48 on page 86)

CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)

Maximum protrusion: 5.1 mm (see figure 49 on page 87)

ADC 14 bit

Pixel format Only monochrome: Mono8, Mono12Packed, Mono12

Only color: BayerGB8, BayerGB12Packed, BayerGB12, Mono8,

RGB8Packed, YUV411Packed, YUV422Packet, YUV444Packed,

BGR8Packed, RGBA8Packed, BGRA8Packed

Frame rates Up to 17 fps

Gain control Manual: 0–33 dB (1 dB/step); auto gain (select. ROI)

Exposure time 31 µs to 60 s; auto shutter (select. ROI)

External trigger event Rising edge, falling edge, any edge, level high, level low

External trigger delay 0 to 60 seconds in 1 µs increments

Fixed rate control 1 fps to maximum frame rate (steps of 0.1 fps)

Imaging modes Free-running, external trigger, fixed rate, software trigger

Sync Out modes Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO

Internal image memory 32 MByte, up to 22 frames

Smart functions Auto gain control, auto exposure control, 32 MByte image memory, bin-

ning (monochrome binning, also for color cameras; but no color bin-

ning), decimation (sub-sampling), config files (user sets), LUT

only color: auto white balance, color correction, edge filter (sharpness),

hue, saturation

I/O Two configurable optocoupled inputs, two configurable optocoupled

outputs

RS232 port (serial port)

Table 11: Specification Manta G-146B/C

Note



The number of frames (StreamHoldCapacity) depends on resolu-

tion and pixel format. Listed number of frames is typical for full

resolution and Mono8/Bayer8.