Instruction manual

Controlling image capture
Guppy PRO Technical Manual V2.0.3
145
One-shot command on the bus to start of
exposure
The following sections describe the time response of the camera using a sin-
gle frame (one-shot) command. As set out in the IIDC specification, this is
a software command that causes the camera to record and transmit a single
frame.
The following values apply only when the camera is idle and ready for use.
Full resolution must also be set.
Microcontroller sync is an internal signal. It is generated by the microcon-
troller to initiate a trigger. This can either be a direct trigger or a release for
ExSync if the camera is externally triggered.
Feature Value
One-shot  microcontroller sync 150 µs (processing time in the
microcontroller)
µC-Sync/ExSync  integration start 8 µs
Table 63: Values for one-shot