Instruction manual

Controlling image capture
Points to pay attention to when working with a sequence:
If more images are recorded than defined in gt se fo la
rem eff
If sequence m camera can use the FIFO for other tasks. For this reason,
a s ence m to the amer after sequence mode has been cancelled.
To repeat the sequence, stop the camera and send e “MultiShot” or “IsoEnable” command
again. Each of these two commands resets the sequence.
 Using Single tion
SingleShot mode restarts the sequence every time.
The quenc when etting th AutoRewind flag. For this reason it is
important to set the flag before the “MultiShot” O_E ” c nds
If t sequen ferr tran ort feature, the number of images entered
in _Lengt d.
The following screenshot shows an example of a sequence for eight different image settings. It
ses the AVT program AVTFiretool as graphical representation. Please note the changes in the
shutter time; that creates descending image brightness, and the change in the image position;
which creates a pa
h ,the ttings r the st imageSeqLen
ain in ect.
ode is cancelled, the 
equ ust be loaded back in c a
th
Shot mode in combina with a sequence does not make sense, because

se e may not be active s e 
or “IS nable omma .
he ce is used with the de ed sp
Seq

h may not be exceede
u
nning effect.
Figure 62: Example of sequence mode settings
9.9.1 Changing the parameters within a sequence
To change the parameter set for one image, it is not necessary to modify the settings for the
entire sequence. The image can simply be selected via the ImageNo field and it is then possible
to change the corresponding IIDC v. 1.3 registers.
MARLIN Technical Manua
l
Page 107