Instruction manual

Camera interfaces
The following diagram illustrates the dependencies of the various output signals.
Figure 26: Output Impulse Diagram
 Note that the polarity of the signals can be changed.
 Firing a new trigger while IntEna is still active can result in image corruption due to double
exposure occurring.
 Note that trigger delay in fact delays the image capture whereas the IntEna_Delay only
delays the leading edge of the IntEna output signal but does not delay the image capture.
 As mentioned before, it is possible to set the outputs by software. Doing so, the achievable
maximum frequency is strongly dependent on individual software capabilities. As a rule of
thumb, the camera itself will limit the toggle frequency to not more than 700 Hz.
MARLIN Technical Manua
l
Page 47