Instruction manual
Marlin Technical ManualV.2.7.0
13
Introduction
continued from previous page
V2.4.0
[continued]
15.08.2008
[continued]
Added detailed level values of I/Os in Chapter Camera I/O con-
nector pin assignment .
Added little endian vs. big endian byte order in Chapter
GPDATA_BUFFER
Added RoHS in Chapter Conformity
Listed shutter speed with offset in Chapter Specifications
New measurement of IntEna signals, therefore new offsets in
Chapter Exposure time (shutter) and offset and in Figure 74:
Data flow and timing after end of exposure on page 148.
New photo of LED position in Figure 22: Position of Status LEDs
on page 47
V2.5.0 23.02.2010 Revised advanced register 0xF1000290 (DSNU_CONTROL) in
Table 111: Advanced register: DSNU on page 210
All advanced registers in 8-digit format beginning with 0xF1... in
Chapter Advanced features (Allied Vision-specific)
Firing a new trigger while IntEna is still active can result in miss-
ing image (not image corruption): see Caution on page 56.
Revised chapter Chapter White balance
Calculated effective chip size for all sensors (with resolution of
Format_7 Mode_0) in Chapter Specifications
Corrected drawing in Figure 83: Delayed integration timing on
page 212
Revised chapter Marlin F-131B (b/w also: NIR) on page 29 (NIR
only with b/w camera)
Added Marlin F-146C Format_0 Mode_5 Mono8 in Table 44: Video
fixed formats Marlin F-146B / F-146C on page 114.
Revised Chapter Conformity .
Corrected: Marlin F-131B/C and Marlin F-131B NIR: power only
via 1394 cable (not via 12-pin HIROSE): Table 9: Specification
Marlin F-131B (b/w also: NIR) on page 29
Corrected: Misc. Features to Mirror image in bit [15] on page
200
to be continued on next page
Version Date Remarks
Table 1: Document history