Instruction manual
Marlin Technical ManualV.2.7.0
73
Description of the data path
Auto gain
In combination with auto white balance, all Marlin CCD models are equipped
with auto gain feature.
When enabled auto gain adjusts the gain within the default gain limits (see Table
32: Manual gain range of the various Marlin types on page 75) or within the lim-
its set in advanced register F1000370h in order to reach the brightness set in
auto exposure register as reference.
Increasing the auto exposure value (aka target grey value) increases the aver-
age brightness in the image and vice versa.
The applied algorithm uses a proportional plus integral controller (PI control-
ler) to achieve minimum delay with zero overshot.
The following table shows both the gain and auto exposure CSR.
Register Name Field Bit Description
0xF0F00820 GAIN Presence_Inq [0] Presence of this feature:
0: N/A
1: Available
Abs_Control [1] Absolute value control
O: Control with value in the value field
1: Control with value in the absolute
value CSR
If this bit= 1 the value in the value field
has to be ignored
--- [2..4] Reserved
One_Push [5] Write: Set bit high to start
Read: Status of the feature:
Bit high: WIP
Bit low: Ready
ON_OFF [6] Write: ON or OFF this feature
Read: read a status
0: OFF
1: ON
A_M_MODE [7] Set bit high for Auto feature Read for
Mode; 0= MANUAL; 1= AUTO
--- [8..19] Reserved
Value [20..31] Read/Write Value
This field is ignored when writing the
value in Auto or OFF mode.
If readout capability is not available read-
ing this field has no meaning
Table 30: CSR: Gain