Instruction manual

Camera interfaces
MARLIN Technical Manual
Page 24
7 Camera interfaces
In addition to the two status LEDs, there are two jacks located at the rear of the camera. The
12-pin HiRose plug provides different control inputs and output lines. The IEEE-1394 connector
with lock mechanism provides access to the IEEE-1394 bus and thus makes it possible to control
the camera and output frames.
Figure 16: Rear view of camera
7.1 IEEE-1394 port pin assignment
The IEEE-1394 plug is designed for industrial use and has the following pin assignment as per
specification:
Pin Signal Pin Signal
1 Cable
power
4 TPB+
2 Cable
GND
5 TPA-
3 TPB- 6 TPA+
Figure 17: IEEE-1394 connector
Table 11: IEEE-1394 pin assignment