User Manual

Camera interfaces
PIKE Technical Manual V5.1.2
113
Camera I/O connector pin assignment
Figure 58: Camera I/O connector pin assignment
Note

GP = General Purpose
For a detailed description of the I/O connector and its
operating instructions see the Hardware Installation Guide,
Chapter PIKE input description.
Read all Notes and Cautions in the Hardware Installation
Guide, before using the I/O connector.
1
102
9
8
7
6
12113
4
5
Pin Signal Direction Level Description
1 External GND GND for RS232 and ext.
power
External Ground for RS232
and external power
2 External Power +8...+36 V DC Power supply
3 Camera Out 4 Out Open emitter Camera Output 4
(GPOut4)
default: -
4 Camera In 1 In U
in
*(high) = 3 V...U
inVCC
U
in
(low) = 0 V...0.8 V
Camera Input 1
(GPIn1)
default: Trigger
5 Camera Out 3 Out Open emitter Camera Output 3
(GPOut3)
default: Busy
6 Camera Out 1 Out Open emitter Camera Output 1
(GPOut1)
default: IntEna
7 Camera In GND In Common GND for inputs Camera Common Input
Ground (In GND)
8 RxD RS232 In RS232 Terminal Receive Data
9 TxD RS232 Out RS232 Terminal Transmit Data
10 Camera Out
Power
In Common VCC for
outputs
max. 36 V DC
External Power
for digital outputs
(OutVCC)
11 Camera In 2 In U
in
*(high) = 3 V...U
inVCC
U
in
(low) = 0 V...0.8 V
Camera Input 2
(GPIn2)
default: -
12 Camera Out 2 Out Open emitter Camera Output 2
(GPOut2)
default: Follow CameraIn2
*min. 5 mA input current; U
in
depends on input current.