User Manual

Description of the data path
PIKE Technical Manual V5.1.2
137
The following window opens:
2. To perform an automatic channel adjustment, click on Do one-push
adjustment.
3. If the adjustment is not sufficient, repeat this step or adjust by clicking
the arrow buttons.
The two channels are automatically adjusted. For the channel adjustment a
region from +/- 20 pixel around the middle vertical is taken into account.
Dual-tap offset adjustment with SmartView (1.10 or greater)
Prerequisites:
•Lens cap
• Test sheet with continuous b/w gradient
Figure 70: SmartView: channel adjustment (>1.5 up to 1.9.1)
Note

Program button is only available for AVT factory.
Figure 71: Example of channel adjustment: PIKE F-032B
before after