User Manual

Introduction
PIKE Technical Manual V5.1.2
18
continued from last page
V4.1.0
[continued]
20.08.08
[continued]
[continued: Restructuring of Pike Technical Manual:]
Revised Chapter Configuration of the camera on page 292
Revised Chapter Firmware update on page 379
Added Chapter Sensor position accuracy of AVT cameras on page
378
Revised Chapter Index on page 381
Corrected for all Pike cameras: 16 user-defined LUTs in Chapter
Specifications on page 86ff.
Added cross-reference from upload LUT to GPDATA_BUFFER in
Chapter Loading an LUT into the camera on page 162.
Added cross-reference from upload/download shading image
to GPDATA_BUFFER in:
Chapter Loading a shading image out of the camera on page 158
Chapter Loading a shading image into the camera on page 159
Added PIKE F-505 as it uses different BAYER pattern (first pixel of
the sensor is RED) in Chapter Color interpolation (BAYER demo-
saicing) on page 195
Added detailed level values of I/Os in Chapter Camera I/O con-
nector pin assignment on page 113.
Added RoHS in Chapter Conformity on page 33
Added little endian vs. big endian byte order in Chapter
GPDATA_BUFFER on page 376
PIKE update firmware round:
Gain references: see Chapter User adjustable gain references on
page 377
Low-noise binning mode for 2 x horizontal binning: see Chapter
Low-noise binning mode (only 2 x H-binning) on page 358
New photo of LED positions in Figure 59: Position of status LEDs
on page 114
V4.2.0 01.09.08 New default gain references for Pike F-505B/C in Table 199:
Default gain references of Pike models on page 377
to be continued on next page
Version Date Remarks
Table 1: Document history