User Manual

ManualsBrandsALLIED Vision Technologies ManualsCamcordersPike F-1600

221

222

223

224

225

226

227

228

229

230

Controlling image capture

PIKE Technical Manual V5.1.2

229

Which new sequence mode features are

available?

New features:

• Repeat one step of a sequence n times where n can be set by the variable

ImageRepeat in SEQUENCE_PARAM.

• Define one or two hardware inputs in Input mode field of IO_INP_CTRL as:

– Sequence step input (if two are set as input, they are AND gated) or

– Sequence reset input

Setup mode

The SetupMode flag allows you to set up a sequence while capturing images.

Using this flag you get a visual feedback of the settings. Set this flag when set-

ting up the sequence and reset the flag before using the sequence.

I/O controlled sequence stepping mode

The I/O controlled sequence stepping mode can be done level controlled or

edge controlled:

The I/O controlled sequence stepping mode can be set for every single sequence

entry. Thus a sequence can be controlled in a very flexible manner.

Note



From now on:

sequence step is I/O controlled sequence stepping mode

sequence reset is I/O controlled sequence pointer reset

Level controlled Edge controlled

• As long as the input is in high

state the sequence pointer will be

incremented from image to

image.

• Can be combined with Quick For-

mat Change Modes. See Chapter

Standard Parameter Update Tim-

ing on page 185 and Chapter

New: Quick Format Change Mode

(QFCM) on page 185.

• Level change is asynchronous to

image change.

• A rising edge on the input will

cause one pointer increment

immediately.