User Manual

Configuration of the camera

PIKE Technical Manual V5.1.2

345

Frame information

This register can be used to double-check the number of images received by the

host computer against the number of images which were transmitted by the

camera. The camera increments this counter with every FrameValid signal. This

is a mirror of the frame counter information found at 0xF1000610.

The FrameCounter is incremented when an image is read out of the sensor.

The FrameCounter does not indicate whether an image was sent over the IEEE

1394 bus or not.

Input/output pin control

0xF1000270 FRAMEINFO Presence_Inq [0] Indicates presence of this fea-

ture (read only)

ResetFrameCnt [1] Reset frame counter

--- [1..31] Reserved

0xF1000274 FRAMECOUNTER FrameCounter [0..31] Number of captured frames

since last reset

Table 164: Advanced register: Frame information

Note



• See Chapter Input/output pin control on page 117

• See Chapter IO_INP_CTRL 1-2 on page 118

• See Chapter IO_OUTP_CTRL 1-4 on page 122

• See Chapter Output modes on page 123