User Manual

Configuration of the camera
PIKE Technical Manual V5.1.2
359
Software feature control (disable LEDs / switch
single-tap and dual-tap)
The software feature control register allows to enable/disable some features of
the camera (e.g. disable LEDs or switch single-tap and dual-tap for Pike F-1100/
1600). The settings are stored permanently within the camera and do not
depend on any user set.
Disable LEDs
• To disable LEDs set bit [17] to 1.
• To disable LEDs in SmartView:
Adv3 tab, activate Disable LED functionality check box.
The camera does not show any more the status indicators during normal opera-
tion:
Examples:
• Power on is not shown
• Isochronous traffic is not shown
• Asynchronous traffic is not shown
Register Name Field Bit Description
0xF1000640 SWFEATURE_CTRL Presence_Inq [0] Indicates presence of this feature
(read only)
BlankLED_Inq [1] Indicates presence of Disable LEDs
feature.
DigitizationTaps_Inq [2] Indicates presence of Sensor
digitization taps feature.
--- [3..5] Reserved
SensorTaps_Inq [6] Indicates presence of Sensor taps
feature.
--- [7..15] Reserved
--- [16] Reserved
BlankLED [17] 0: Behavior as described in Chapter
Status LEDs on page 94ff.
1: Disable LEDs. (Only error codes
are shown.)
DigitizationTaps [18..21] 0: single-tap
1: dual-tap
SensorTaps [22..25] Max number of taps -1
--- [26..31] Reserved
Table 180: Advanced register: Software feature control (disable LEDs/
switch single-tap and dual-tap )