User Manual

Specifications
PIKE Technical Manual V5.1.2
96
PIKE F-505B/C (fiber)
Feature Specification
Image device Type 2/3 (diag. 11.0 mm) progressive scan SONY ICX625ALA/AQA with
Super HAD microlens
Effective chip size 8.5 mm × 7.1 mm
Cell size 3.45 μm x 3.45 μm
Picture size (max.) 2452 x 2054 pixels (Format_7 Mode_0)
Lens mount Adjustable C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
mechanical flange back to filter distance: 12.5 mm
(see Figure 20: Pike C-Mount dimensions (large filter) on page 64)
ADC 14 bit
Color modes Only color: Raw8, Raw12, Raw16, Mono8, YUV422, YUV411, RGB8
Frame rates 1.875 fps; 3.75 fps; 7.5 fps; 15 fps
up to 14* fps in Format_7 (Mono8 no sub-sampling)
* at 11000 bytes per packet
Gain control Manual: 0-24 dB (0.0359 dB/step); auto gain (select. AOI)
Shutter speed 27 μs … 67,108,864 μs (~67s); auto shutter (select. AOI)
External trigger shutter Programmable, trigger level control, single trigger,
bulk trigger, programmable trigger delay
Internal FIFO memory Up to 5 frames
Look-up tables 16 user-defined (14 bit  14 bit); gamma (0.45 and 0.7)
Smart functions AGC (auto gain control), AEC (auto exposure control), real-time shad-
ing correction, LUT, 64 MByte image memory, mirror, binning, sub-
sampling, High SNR, storable user sets
only color: AWB (auto white balance), color correction, hue, satura-
tion, sharpness
Two configurable inputs, four configurable outputs
RS-232 port (serial port, IIDC V1.31)
Transfer rate 100 Mbit/s, 200 Mbit/s, 400 Mbit/s, 800 Mbit/s
Digital interface IEEE 1394b (IIDC V1.31), 2 x copper connectors (bilingual) (daisy
chain)
fiber: IEEE 1394b, 2 connectors: 1 x copper (bilingual), 1 x GOF con-
nector (2 x optical fiber on LCLC), (daisy chain)
Power requirements DC 8 V - 36 V via IEEE 1394 cable or 12-pin HIROSE
Power consumption Typical 5.75 W (@ 12 V DC);
fiber: typical 6.50 W (@ 12 V DC)
Table 20: Specification PIKE F-505B/C (fiber)