User guide

Introduction
STINGRAY Technical Manual V4.4.4
21
continued from last page
V4.3.0 15.09.09 Minor corrections:
Notice about connection between temperature at sensor
and temperature at camera housing on page 291.
Corrected registers for IO_OUTP_PWM2/3/4 in Table 30:
PWM configuration registers on page 106 and in Table 127:
Advanced registers summary on page 292ff.
Revised Chapter Conformity on page 30.
New drawings to show maximum protrusion: Figure 35:
Stingray CS-Mount dimension on page 84 and Figure 36:
Stingray C-Mount dimensions on page 85
New values for maximum protrusion: tables in Chapter
Camera dimensions on page 71ff.
Corrected addresses of debounce registers:
Advanced register summary 0xF1000840 on page 295
Advanced register summary 0xF1000850 on page 295
Advanced register summary 0xF1000860 on page 295
Advanced register summary 0xF1000870 on page 295
Table 64: Advanced register: Debounce time for input
ports on page 193
Stingray cameras with serial numbers S/N greater
09/17-285831532 have a heat sink and thus the mass of
the camera increases from 92 g up to 108 g: see Chapter
Specifications on page 46ff.
New front flange:
Title page: new Stingray photo
New CAD drawings:
All CAD drawings in Chapter Camera dimensions on
page 71ff.
Cross section drawings in Figure 35: Stingray CS-Mount
dimension on page 84 and Figure 36: Stingray C-Mount
dimensions on page 85. Note: Adjustments by means
of the adjustment spacer(s) have to to be done in the
AVT factory. Contact Customer Care.
Figure 41: Board level camera: two IEEE 1394b FireWire
connectors on page 91
Figure 43: Board level camera: I/O pin assignment on
page 93
2x/4x/8x binning:
Stingray F-504C has now also the usual 2x/4x/8x binning (no
color binning): see Chapter Binning (only Stingray b/w and F-
201C/504C) on page 146ff. and Chapter Binning and sub-sam-
pling access on page 159ff. and Table 18: Specification STING-
RAY F-504B/C (fiber) on page 60
to be continued on next page
Version Date Remarks
Table 1: Document history