User guide
Introduction
STINGRAY Technical Manual V4.4.4
23
continued from last page
V4.4.1 07.01.11 • Minor corrections
• Converted FrameMaker files from FM7 to FM9
• Added required minimum number of GrabCount value (2)
for HIGH_SNR ON in Table 151: Advanced register: High Sig-
nal Noise Ratio (HSNR) on page 321
• Added info that for 8-bit video modes, the internal HSNR
calculations are done with 14 bit: Chapter High SNR mode
(High Signal Noise Ratio) on page 168
• Changed tripod drawing: added dimensions of three big
holes (M6 and UNC 1/4-20) in Figure 25: Tripod dimensions
on page 74.
• Added Windows 7 support and revised Windows XP/
Windows Vista in in Chapter FireWire and operating
systems on page 42
V4.4.2 15.04.11 • Added sensitivity curves for Stingray F-125B/F-125C:
see Figure 13: Spectral sensitivity of Stingray F-125B on
page 66 and
see Figure 14: Spectral sensitivity of Stingray F-125C
(without IR cut filter) on page 66
C-/CS-Mount no more adjustable, for modifications contact
Customer Care and send camera to AVT:
• See Chapter Specifications on page 46ff.
• See Chapter Adjustment of C-Mount and CS-Mount on page
85.
Stingray firmware update round:
• Defect pixel correction: you don’t need to set value for
brightness to max. any more: see Figure 66: Defect pixel
correction: build and store on page 142 and Chapter Grab
an image with defect pixel data on page 143
• Besides in Mono8 mode defect pixel correction is also
possible in Raw8 mode: see note in Chapter Building
defect pixel data on page 143
• Revised Chapter Defect pixel correction on page 140
• Image is shot internally during calculating a mean value:
see note in Chapter Calculate defect pixel coordinates on
page 143
• Activate HSNR mode to improve defect pixel correction:
see note in Chapter Building defect pixel data on page 143
• Added descriptions for defect pixel correction in F7 modes:
see Chapter Building defect pixel correction image in
Format_7 modes on page 141
to be continued on next page
Version Date Remarks
Table 1: Document history