User guide

Configuration of the camera

STINGRAY Technical Manual V4.4.4

335

Software feature control (disable LEDs)

The software feature control register allows to enable/disable some features

of the camera (e.g. disable LEDs). The settings are stored permanently within

the camera and do not depend on any user set.

Disable LEDs

• To disable LEDs set bit [17] to 1.

• To disable LEDs in SmartView:

Adv3 tab, activate Disable LED functionality check box.

The camera does not show any more the status indicators during normal oper-

ation:

Examples:

• Power on is not shown

• Isochronous traffic is not shown

• Asynchronous traffic is not shown

0xF1000640 SWFEATURE_CTRL Presence_Inq [0] Indicates presence of this feature

(read only)

BlankLED_Inq [1] Indicates presence of Disable

LEDs feature.

--- [2..15] Reserved

--- [16] Reserved

BlankLED [17] 0: Behavior as described in Chap-

ter Status LEDs on page 94ff.

1: Disable LEDs. (Only error codes

are shown.)

--- [18..31] Reserved

Table 165: Advanced register: Software feature control (disable LEDs)

Note



During the startup of the camera and if an error condition

is present, the LEDs behave as described in Chapter Status

LEDs on page 94ff.