User guide

Camera interfaces
STINGRAY Technical Manual V4.4.4
95
Normal conditions
Error conditions
Event LED1 LED2
Camera startup During startup all LEDs are switched on consecu-
tively to show the startup progress:
Phase1:
LED1 RED
Phase2: LED1 RED + LED1 GREEN
Phase3: LED1 RED + LED1 GREEN + LED2 RED
Phase4: LED1 RED + LED1 GREEN + LED2 RED +LED2 GREEN
Power on GREEN
Bus reset GREEN blinking
Asynchronous traffic +GREEN pulsing GREEN
Only GOF:
asynchronous traffic
+GREEN pulsing
(inverted)
GREEN
Only GOF:
GOF signal detect
GREEN GREEN
Isochronous traffic +RED pulsing GREEN
Waiting for external
trigger
RED GREEN
External trigger event RED +RED pulsing
Table 20: LEDs showing normal conditions
LED1 RED
LED2 GREEN
Warning
1 pulse
DCAM
2 pulse
MISC 
3 pulse
FPGA
4 pulse
Stack
5 pulse
FPGA boot error 1-5 pulse
Stack setup 1 pulse
Stack start 2 pulse
No FLASH object 1 pulse
No DCAM object 1 pulse
Register mapping 3 pulse
VMode_ERROR_STATUS 1 pulse
FORMAT_7_ERROR_1 2 pulse
FORMAT_7_ERROR_2 3 pulse
Table 21: Error codes