Specifications

C613-10506-01-REV A Software Release Note AlliedWare Plus Version 5.4.2-0.1 17
show debugging ip dns
forwarding
show debugging ip packet
show hosts
show debugging ip dns
forwarding
show ip dns forwarding
cache
show ip domain-list
show ip domain-name
show ip forwarding
show ip interface
show ip irdp
show ip irdp interface
show ip name-server
Modified Y Y Y Y IP Addressing
and Protocol
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show ip interface vrf Modified – Y Y Y IP Addressing
and Protocol
Commands
This command is now available from
the User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
ipv6 address Modified Y Y Y Y IPv6 Commands You can now use this command to set
the IPv6 address of a VLAN interface
and enable IPv6 with an optional eui64
parameter to apply the MAC address
of the interface. Note that the MAC
address of the default VLAN is applied
if the interface does not have a MAC
address of its own when specifying the
eui64 parameter.
ipv6 address autoconfig New Y Y Y Y IPv6 Commands Use this new command to enable IPv6
stateless address autoconfiguration
(SLAAC) on an interface This
configures an IPv6 address on an
interface derived from the MAC
address on the interface.
ipv6 enable Modified Y Y Y Y IPv6 Commands This revised command now enables
IPv6 with a IPv6 link-local address not
with an IPv6 global address. Use this
command to enable IPv6 on an
interface without an IPv6 global
address set for the interface.
ipv6 nd current-hoplimit New – – Y Y IPv6 Commands Use this new command to specify the
advertised current hop limit used
between IPv6 Routers.
Table 4: New and modified commands in 5.4.2-0.1
Command Status
x600 x610 x900
SBx908
Software
Reference
Chapter
Description