Specifications

18 Software Release Note AlliedWare Plus Version 5.4.2-0.1 C613-10506-01-REV A
ipv6 nd minimum-ra-
interval
New Y Y Y Y IPv6 Commands Use this new command in Interface
Configuration mode to set a minimum
Router Advertisement (RA) interval
for a VLAN interface. Use the no
variant of this command in Interface
Configuration mode to remove the
minimum RA interval for a VLAN
interface.
ipv6 nd prefix Modified Y Y Y Y IPv6 Commands The no-autoconfig and offlink
parameters have been added to this
command. The all parameter has been
added to the no variant of this
command. Use this command to
specify the IPv6 prefix information that
is advertised by the router
advertisement for IPv6 address auto-
configuration. Use the no parameter
with this command to reset the IPv6
prefix.
ipv6 nd ra-interval Modified Y Y Y Y IPv6 Commands The Router Advertisements (RA)
interval range has changed from <3-
1800> seconds to <4-1800> seconds.
Use this revised command to specify
the interval between IPv6 RA
transmissions. The no variant of this
command resets the IPv6 RA interval
to the default of 600 seconds.
ipv6 nd retransmission-time New Y Y Y Y IPv6 Commands Use this new command to specify the
advertised retransmission interval for
Neighbor Solicitation in milliseconds
between IPv6 Routers.
ipv6 opportunistic-nd New Y Y Y Y IPv6 Commands Use this new command to enable
opportunistic neighbor discovery for
the global IPv6 ARP cache. Use the no
variant of this command to disable
opportunistic neighbor discovery for
the global IPv6 ARP cache.
Opportunistic neighbor discovery
changes the behavior for unsolicited
ARP packet forwarding on the switch.
show ipv6 forwarding
show ipv6 interface brief
show ipv6 neighbors
show ipv6 route
show ipv6 route summary
Modified Y Y Y Y IPv6 Commands These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show ip route
show ip route database
show ip route summary
Modified YYYYRouting
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
Table 4: New and modified commands in 5.4.2-0.1
Command Status
x600 x610 x900
SBx908
Software
Reference
Chapter
Description