Specifications

22 Software Release Note AlliedWare Plus Version 5.4.2-0.1 C613-10506-01-REV A
max-static-routes Modified – Y Y Y VRF-Lite
Commands
This command now enables you to set
the maximum number of static routes
(excluding FIB—Forwarding
Information Base routes) for VRF
Instances.
show ip vrf
show ip vrf detail
show ip vrf
Modified – Y Y Y VRF-Lite
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
ip multicast route New Y Y Y Y Multicast
Introduction and
Commands
Use this command to add a static
multicast route for a specific multicast
source and group address to the
multicast Routing Information Base
(RIB).
ip multicast wrong-vif-
suppression
New YYYYMulticast
Introduction and
Commands
Use this command to prevent
unwanted multicast packets received
on an unexpected VLAN being
trapped to the CPU.
show ip mroute
show ip mvif
show ip rpf
Modified YYYYMulticast
Introduction and
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
ip igmp ssm New Y Y Y Y IGMP and IGMP
Snooping
Commands
Use this command to define a non-
default Source Specific Multicast (SSM)
range of IP multicast addresses in IGMP.
Incoming IGMPv1 and IGMPv2 join
requests are ignored if the multicast IP
address is in the SSM range and no
SSM mapping is configured for these
addresses. By default, the SSM range is
232/8.
ip igmp ssm-map enable New Y Y Y Y IGMP and IGMP
Snooping
Commands
Use this command to enable Source
Specific Multicast (SSM) mapping on
the device.
ip igmp ssm-map static New Y Y Y Y IGMP and IGMP
Snooping
Commands
Use this command to specify the static
mode of defining Source Specific
Multicast (SSM) mapping. SSM statically
assigns sources to IGMPv1 and IGMPv2
groups to translate such (*,G) groups’
memberships to (S,G) memberships
for use with PIM-SSM.
ip igmp startup-query-
count
New Y Y Y Y IGMP and IGMP
Snooping
Commands
Use this command to configure the
IGMP startup query count on a VLAN
interface in Interface Configuration
mode. The IGMP startup query count
is the number of general query
messages sent at startup. The default
IGMP startup query count is 2.
Table 4: New and modified commands in 5.4.2-0.1
Command Status
x600 x610 x900
SBx908
Software
Reference
Chapter
Description