Specifications

24 Software Release Note AlliedWare Plus Version 5.4.2-0.1 C613-10506-01-REV A
show debugging pim dense-
mode
show ip pim dense-mode
interface
show ip pim dense-mode
interface detail
show ip pim dense-mode
mroute
show ip pim dense-mode
neighbor
show ip pim dense-mode
neighbor detail
show ip pim dense-mode
nexthop
Modified Y Y Y Y PIM-DM
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show ipv6 mld groups
show ipv6 mld interface
show ipv6 mld snooping
mrouter
show ipv6 mld snooping
statistics
Modified Y Y Y Y MLD Snooping
Introduction and
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show access-group Modified – – Y Y IPv4 Hardware
Access Control
List (ACL)
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show access-list (IPv4
Hardware ACLs)
Modified Y Y Y Y IPv4 Hardware
Access Control
List (ACL)
Commands
This command is now available from
the User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
show access-list (IPv4
Software ACLs)
show dos interface
show ip access-list
show ip prefix-list
Modified Y Y Y Y IPv4 Software
Access Control
List (ACL)
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show ipv6 access-list (IPv6
Hardware ACLs)
Modified – – Y Y IPv6 Hardware
Access Control
List (ACL)
Commands
This command is now available from
the User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
ipv6 access-list extended
proto
New YYYYIPv6 Software
Access Control
List (ACL)
Commands
Use this command when configuring an
IPv6 extended access-list for filtering
frames that permit or deny packets
with a specific value based on the IP
protocol number specified. The no
variant of this command removes a
specified IPv6 extended access-list with
an IP protocol number.
show ipv6 access-list (IPv6
Software ACLs)
Modified Y Y Y Y IPv6 Software
Access Control
List (ACL)
Commands
This command is now available from
the User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
Table 4: New and modified commands in 5.4.2-0.1
Command Status
x600 x610 x900
SBx908
Software
Reference
Chapter
Description