Specifications

C613-10506-01-REV A Software Release Note AlliedWare Plus Version 5.4.2-0.1 29
type stack master-fail New – – – – Trigger
Commands
This command initiates the action of a
pre-configured trigger to occur when
the Control Fabric Card enters the fail-
over state.
type usb New ––––Trigger
Commands
Use this command to configure a
trigger that activates on either the
removal or the insertion of a USB
storage device.
show counter ping-poll
show ping-poll
Modified Y Y Y Y Ping Polling
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show debugging sflow Modified Y Y Y Y sFlow
Commands
This command is available from the
User Exec command mode prompt
(awplus>) and the Privileged Exec
command mode prompt (awplus#).
show counter stack
show debugging stack
show provisioning (stack-
member)
Modified YYYYStacking
Commands
These commands are now available
from the User Exec command mode
prompt (awplus>) and the Privileged
Exec command mode prompt
(awplus#).
show stack resiliencylink New Y Y Y Y Stacking
Commands
Use this command to display
information about the current status of
the resiliency-link across the members
of the stack.
stack mixed-mode New – Y – – Stacking
Commands
Use this command to combine x610
and x600 switches in a VCStack.
switch provision Modified – Y – – Stacking
Commands
Two additional parameters have added
that allow you to provision either an
x610-24 or an x610-48 switch as a
stack member.
Table 4: New and modified commands in 5.4.2-0.1
Command Status
x600 x610 x900
SBx908
Software
Reference
Chapter
Description