Specifications

GS660 Technical Manual Page 16
Gigabit Ethernet Setup for Windows
o Install network card in computer.
o Boot the PC and cancel the “Found new Hardware Wizard” window that may appear when
Windows detects the new card.
o Install the driver that came with the network card.
o Once the driver is installed, open the Network Connections Dialog as follows: From the
Windows desktop select start, then select Control Panel, then double click on the Network
Connections icon. Double click the relevant network card listed or right-click the relevant
network card and select Properties. This will open the properties window for your network
card. See Figure 4.
Figure 4. Network card main properties window.
o Select the Internet Protocol (TCP/IP) check box and then select Properties. See Figure 5.
Network card TCP/IP address.. Select the Use the following IP address and enter an IP address
of 169. 254. x. y, where x and y can be any number. Press the TAB key after entering the IP
address and the subnet mask will automatically be entered. The subnet mask is 255. 255. 0. 0.
Click OK to save changes. Note that if Windows reports a conflict with the above IP address,
simply repeat the above steps and change the last digit of the IP address to a different value.