Instruction manual

Table Of Contents

Configuration of the camera

PIKE Technical Manual V3.1.0

242

Soft Reset

The SOFT_RESET feature is similar to the INITIALIZE register, with the follow-

ing differences:

• 1 or more bus resets will occur

• the FPGA will be rebooted

The reset can be delayed by setting the Delay to a value unequal to 0 - the

delay is defined in 10 ms steps.

High SNR mode (High Signal Noise Ratio)

With High SNR mode enabled the camera internally grabs GrabCount images

and outputs a single averaged image.

0xF1000510 SOFT_RESET Presence_Inq [0] Indicates presence of this

feature (read only)

--- [1..5] Reserved

Reset [6] Initiate reset

--- [7..19] Reserved

Delay [20..31] Delay reset in 10 ms steps

Table 131: Soft reset register

Note

When SOFT_RESET has been defined, the camera will respond

to further read or write requests but will not process them.

0xF1000520 HIGH_SNR Presence_Inq [0] Indicates presence of this feature

(read only)

--- [1..5] Reserved

ON_OFF [6] High SNR mode on/off

--- [7..22] Reserved

GrabCount [23..31] Number of images (min. 2)

images with n=1..8 (automati-

cally)

Table 132: High Signal Noise Ratio (HSNR)