Technical information

and channel page. There are 23 channel groups available. Each
group can contain from 1 to 100 channels. The contents of a channel
group can be reviewed by placing the cursor over the list of channels
on the second line and pushing the VAR knob (PUSH CHAR), then
use the VAR knob to review the list of channels. Program the chan-
nel group as follows:
1. Place the cursor over the channel group index; this is the second
cursorable field.
2. Select the channel group to program.
3. Place the cursor over “Add” or “Del” field. Add adds channels to
the channel group, Del deletes channels.
4. Move the cursor to the channel number field, this is the last field
on the first line.
5. Select the channel to add or delete and press enter. Repeat this
until the channel group is programmed properly. When finished
programming the channel groups, move the cursor over the
ChGrp field and select ScanList.
Programming the Scan List (Scan List Sub-Page)
Select the “Scan List” page. This is a sub-page to the system, pro-
gram, channel page. The scan list is the list of channels that this
radio will scan during ALE scan. One of the channel groups is used
as the scan list. The channel group that is currently being used as
the scan list is identified by the “S” that appears after the channel
group index.
1. Move the cursor over the “ChGrp” field and select “Scan List”.
2. Place the cursor over the channel group index, this is the
number field on the second line.
3. Select the channel group to use as the scan list.
4. Press the ENT key.
5. Press the CLR key to return to the system program page.
ALE ADDRESSES
There is only one sub-page under the system program address page.
All parameters for an address are programmed on this page. There
are several parameters that must be entered for each address, such
as channel group and the associated self. The number of parame-
Services
12-8
KHF 950/990 Pilots Guide
Rev. 0
Dec/96