Technical information
Table Of Contents
- TITLE PAGE
- TABLE OF CONTENTS
- INTRODUCTION
- SECTION I
- CHARACTERISTICS OF HF SSB
- ACRONYMS AND DEFINITIONS
- REFERENCES
- HF SSB COMMUNICATIONS
- FREQUENCY
- SKYWAVE PROPAGATION - WHICH FREQUENCY TO
- WHY SINGLE SIDEBAND IS IMPORTANT IN HF
- AMPLITUDE MODULATION (AM)
- SINGLE SIDEBAND OPERATION
- SINGLE SIDEBAND (SSB)
- SUPPRESSED CARRIER VS. REDUCED CARRIER
- SIMPLEX AND SEMI-DUPLEX OPERATION
- AUTOMATIC LINK ESTABLISHMENT (ALE)
- FUNCTIONS OF HF RADIO AUTOMATION
- HOW ALE ASSURES THAT THE BEST COMMUNICA-TIONS
- CHARACTERISTICS OF HF SSB
- SECTION II
- SECTION III
- SECTION IV
- SECTION V
- SECTION VI
- SECTION VII
- ITU MARITIME RADIOTELEPHONE STATIONS
- DESCRIPTION OF SERVICES
- AT&T HIGH SEAS RADIOTELEPHONE SERVICE
- AT & T COAST STATION COVERAGE MAP
- COAST STATION COVERAGE & INFORMATION
- AIRCRAFT REGISTRATION
- OPERATING PROCEDURES FOR USING THE HIGH SEAS RADIOTELEPHONE NETWORK
- AT&T HIGH SEAS COAST STATIONS
- MOBILE MARINE RADIO, INC.
- WORLDWIDE LISTING OF PUBLIC CORRESPONDENCE STATIONS
- MARITIME RADIOTELEPHONE CHANNEL DESIGNATIONS
- SECTION VIII
- SECTION IX
- SECTION X
- SECTION XI
- SECTION XII
- SECTION XIII
12. Press the ENT key. The response time is displayed.
13. The response time is programmed in intervals of Triple Word
(TW) which is 130.67msec. Set for total Star network call length.
14. Press the ENT key. The network member list will be displayed.
15. This parameter has two cursorable fields, a slot index and an
address field.
16. Move the cursor to the address field. There are two special
identifiers that appear in this field, “end-list” (end of list) and
“self-add” (self address slot).
17. Select the address used in this slot of the Star network.
18. Press the ENT key. The next slot is displayed. Repeat step 19
and 20 until all members of the Star network are entered.
19. Repeat steps 4 through 21 for additional addresses.
Programming a Group Address
1. Place the cursor over the address index; this is the numeric field
on the top line.
2. Select the index of the address to change to a group type of
address.
3. Move the cursor back one position to cover the address type
field, this is the first cursorable field on the top line of the display.
4. Select “GROUP”
5. Press the ENT key. The cursor moves over the address index.
6. Press the ENT key again, the cursor moves over the address
field on the second line.
7. Push the VAR knob (PUSH CHAR), to put the cursor into
character mode. The CLR key, VAR knob and the CRSR knob
can now be used to enter a new group address. This address is
not transmitted. It is used as an identifier for the group, to allow
selection on the ALE page.
8. Press the ENT key. The channel group index is displayed.
9. Select the channel group that has the list of channels that this
address is valid on. This is the list of channels that is used when
placing a call to this group.
Services
12-12
KHF 950/990 Pilots Guide
Rev. 0
Dec/96