Technical Manual

Preliminary Release

5.4 Transmit Power

The 2788 transmitter output power has three power settings:

1 = Low (0.5 W); 2 = Mid (1 W) ; 3 = Hi (2 W)

tp=x<CR>

Examples: tp=1<CR> ; tp=2<CR> ; tp=3<CR>

5.5 Operational Mode

The 2788 has two operational modes:

0 Remote

1 Master

Systems can be configured for single or dual frequency. No advantage in latency is gained by

using two channel frequencies.

Systems use 1 master (om=1) and up to 512 remotes (om=0). It requires that the master have

line of sight to all remote radios.

om=x<CR>

Examples: om=0<CR> ; om=1<CR>

5.6 Group Code

To prevent confusion of two or more separate 2788 systems, there are 16 unique group codes

to distinguish 2788 groups, ranging from 0 to 15. The default group code is 0.

gc=##<CR>

Examples: gc=0<CR> ; gc=1<CR>; gc=15<CR>

5.7 IP Address

Each 2788 radio must be assigned a unique IP address within its LAN subnet group. This permits

both local and remote access of radio configuration and status information. The default IP

address is 192.168.1.128. It must be changed prior to field deployment. The IP address assigned

to the radio is for diagnostic purposes to control and monitor the 2788 locally or remotely.

ip=###.###.###.###<CR>

Examples: ip=10.0.0.100<CR> ; ip=172.16.10.100; ip=192.168.1.10<CR>

If the IP address is changed to a new subnet, make certain that the computer is also changed to

the new subnet.5.8 Telnet Port

The 2788 Telnet port can be reassigned from the default of 23 to any port up to 65535. This

adds additional security to the system.

tnp=#####<CR>