Service manual

-(j
'..
~\
!
wear and chipped or rough teeth. Check the
shafts for worn splines.
Assembly
Place the reverse idle gear, bearings and
shaft in the case first. Install the cork in
the reverse idler ·shaft to prevent loss of
oil.
Install the pinion shaft with the sliding gear,
placing the shift collars towards each other.
Install the loose third speed gear. Install
the thrust washer with the grooved side next
to the third speed gear. Place the spring
washer next, then the bearing and retaining
nut. Adjust the bearings to a slightly pre-
loaded fit, 8 ounce ft. Lock the nut by driv-
ing a portion of the thin section into the key-
way of shaft.
Tractors without the special low gear will
have a spacer to take the place of the gear.
The main shaft is installed from the front
of case, placing the gears on shaft as it enters
case. Install the rear bearing and the low
speed pinion before installing gear spacer.
Adjust bearings to a free rolling fit without
end play or binding by use of shims between
front bearing retainer and case. The oil dam
for the rear main shaft bearing is installed
behind the bearing.
G - 33