Installation Instructions

1
Installation Instructions for
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
Incandescent lamps may be dimmed with a standard incandescent
dimmer. LED lamps may be dimmed with a LED dimmer. Consult
lamp manufacturer for additional information.
1.0
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall
Remove the fixture screws located on the top and bottom of the fixture base using the provided Allen Wrench, then remove the mounting
plate from the fixture base.
Install the mounting plate onto the electrical box with the two #8-32 screws provided.
Connect the fixture to suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the electrical box, mount the fixture back onto the mounting plate, and reinstall
fixture screws (reversal of step 1).
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage information.
1
2
1A
Install the Fixture
3
4
5
6
7
ALLEN WRENCH
FIXTURE SCREW
LAMP
FIXTURE
MOUNTING PLATE
7
4
5
2
1
1
SAVETHESE INSTRUCTIONS!
All rights reserved.
3 and 5 Bath