User manual

ALL-VPN10 VPN/Firewall WLAN-N WAN Router
© ALLNET GmbH München 2013 - All rights reserved
8
#
Setting
Content
Purpose
1
Hardware installation
Configure the network
to meet user’s demand.
Install the device hardware based on user physical
requirements.
2
Login
Login the device with
Web Browser.
Login the device web- based UI.
3
Verify device
specification
Verify Firmware version
and working status.
Verify the device specification, Firmware version
and working status.
Set password and time
Set time and re- new
password.
Modify the login password considering safe issue.
Synchronize time with WAN.
4
Set WAN connection
Verify WAN connection
setting, bandwidth
allocation, and protocol
binding.
Connect to WAN. Configure bandwidth to optimize
data transmission.
5
Set QoS bandwidth
management: avoid
bandwidth occupation
Restrict bandwidth and
session of WAN ports,
LAN IP and application.
To assure transmission of important information,
manage and allocate the bandwidth further to
achieve best efficiency.
6
Set Firewall: prevent
attack and improper
access to network
resources
Block attack, Set Access
rule and restrict Web
access.
Administrators can block BT to avoid bandwidth
occupation, and enable access rules to restrict
employee accessing internet improperly or using
MSN, QQ and P2P during working time. They can
also protect network from Worm or ARP attacking.
7
Advanced Settings：
DMZ/Forwarding, UPnP,
DDNS, MAC Clone
DMZ/Forwarding,
UpnP, Routing Mode,
multiple WAN IP, DDNS
and MAC Clone
DMZ/Forwarding, UPnP, Routing Mode, multiple
WAN IP, DDNS and MAC Clone
8
Management and
maintenance settings:
Syslog, SNMP, and
configuration backup
Monitor VPN Router
working status and
configuration backup.
Administrators can look up system log and monitor
system status and inbound/outbound flow in real
time.