User manual

User Manual
Page 7
The Web User Interface
The Web User Interface of your ALL0238RD allows you to configure the various
features of your ALL0238RD. This will serve as your main tool in monitoring and
configuring all of your ALL0238RD’s main features.
Accessing the Web User Interface
NOTE: To avoid any conflicts in accessing the Web User Interface, it is strongly
advised to do the following:
• Simply access the Web User interface through an Ethernet connection.
This is achieved by connecting your Computer and your ALL0238RD
through an Ethernet cable.
• If present, kindly turn off the wireless adapter of your computer. You
may enable the wireless adapter after completing the setup. This is to
avoid IP address conflict which might block you from accessing the
Web user interface.
• Remove temporary Internet files.
To access the Web User Interface through an Ethernet connection:
1. Connect your computer to the ALL0238RD device using an Ethernet
cable.
NOTE: before proceeding to step 2, please check the SMART LED of the
device; the LED should be in GREEN WEAK status and BLINKING.
2. Launch any web browser. You would automatically be redirected to
your ALL0238RD’s web user interface.
3. If in any case it does not, kindly type 192.168.1.1 on the address bar
and press Enter. You will then be redirected to the Home page of your
ALL0238RD’s web user interface.
4. Upon redirecting, a window showing the wireless networks within range
would appear. You may close this mini window or choose to connect
to your preferred wireless network immediately.