User`s guide

2
Chapter 2
Basic Setup
This Chapter provides details of installing and configuring the Network
Camera.
System Requirements
• To use the wired LAN interface, a standard 10/100BaseT hub or switch and network cable
is required.
• To use the Wireless interface on the Network Camera, other Wireless devices must be
compliant with the IEEE802.11b or IEEE802.11g specifications. All Wireless stations
must use compatible settings.
Installation - Network Camera
1. Assemble the Camera
For the ALL2250 and ALL2211 Network Camera, screw the supplied antenna to the
mounting point on the top. The antenna is adjustable; best results are usually obtained with
the antenna positioned vertically.
2. Connect the LAN Cable
Connect the Network Camera to a 10/100BaseT hub or switch, using a standard LAN
cable.
For the ALL2250 and ALL2211 Network Camera, this disables
the Wireless Interface, because only one interface can be
active.
The LAN cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching the
LAN cable while the camera is powered on does NOT switch
the interface between wired and wireless.
The default Wireless settings are:
Mode: Infrastructure
ESSID: ANY
Wireless Security: Disabled
Domain: USA
Channel No.: Auto
3. Power Up
Connect the supplied power adapter to the Network Camera and power up. Use only the
power adapter provided. Using a different one may cause hardware damage.
4. Check the LEDs
• The Power LED will turn on briefly, then start blinking. It will blink during startup, which
takes 15 to 20 seconds. After startup is completed, the Power LED should remain ON.
6