Operation Manual

V
V
P
P
N
N
D
D
U
U
A
A
L
L
-
-
W
W
A
A
N
N
R
R
o
o
u
u
t
t
e
e
r
r
47
input the DNS IP of the ISP port)
Remote Host:
This is the detected location for the remote Network Segment. This
Remote Host IP should better be capable of receiving feedback stably
and speedily. (Please input the DNS IP of the ISP port).
DNS Lookup Host:
This is the detect location for DNS. (Only a web address such as
www.hinet.net is acceptable here. Do not input an IP address.) In
addition, do not input the same web address in this box for two different
WANs.
Note！
In the load balance mode for Assigned Routing, the first WAN port (WAN1) will be saved for the
traffic of the IP addresses or the application service ports that are not assigned to other WANs (WAN2).
Therefore, in this mode, we recommend assigning one of the connections to the first WAN. When other
WANs (WAN2) are broken and connection error remove (Remove the Connection) has been selected
for the connection detection system, traffic will be shifted to the first WAN (WAN1). In addition, if the first
WAN (WAN1) is broken, the traffic will be shifted to other WANs in turn. For example, the traffic will be
shifted to WAN2.
6.2.3 Protocol Binding
Interface Configuration
Router allows maximum two WAN interface, the bandwidth and real connection of every WAN will impact
the load balance mechanism; therefore you need to set the Bandwidth and the Network service detection by
each WAN Port correctly.
In “WAN Setting”, click “Edit” to enter the WAN port configuration.
Bandwidth Configuration
When Auto Load Balance mode is selected, the device will select sessions or IP and the WAN bandwidth
will automatically allocate connections to achieve load balancing for external connections. The network