Operation Manual

V
V
P
P
N
N
D
D
U
U
A
A
L
L
-
-
W
W
A
A
N
N
R
R
o
o
u
u
t
t
e
e
r
r
50
connections to destination IP address 210.11.1.1 are to be restricted to
WAN1, the external static IP address 210.1.1.1 ~ 210.1.1.1 should be input.
If a range of destinations is to be assigned, input the range such as
210.11.1.1 ~ 210.11.255.254. This means the Class B Network Segment of
210.11.x.x will be restricted to a specific WAN. If only specific Service Ports
need to be designated, while a specific IP destination assignment is not
required, input “0” into the IP boxes.
Interface:
Select the WAN for which users want to set up the binding rule.
Enable:
To activate the rule.
Add To List:
To add this rule to the list.
Delete selected
item:
To remove the rules selected from the Service List.
Moving Up &
Down:
The priority for rule execution depends on the rule order in the list. A rule
located at the top will be executed prior to those located below it. Users can
arrange the order according to their priorities.
Note！
The rules configured in Protocol Binding will be executed by the device according to their priorities
too. The higher up on the list, the higher the priority of execution.
Show Priority：
Click the “Show Table” button. A dialogue box as shown in the following figure will be displayed. Users
can choose to sort the list by priorities or by interface. Click “Refresh” and the page will be refreshed; click
“Close” and the dialogue box will be closed.
Add or Remove Service Port
If the Service Port users want to activate is not in the list, users can add or remove service ports
from “Service Management” to arrange the list, as described in the following：