Operation Manual

V
V
P
P
N
N
D
D
U
U
A
A
L
L
-
-
W
W
A
A
N
N
R
R
o
o
u
u
t
t
e
e
r
r
54
WAN2 from the pull-down option list “Interface”, and then click “Enable”. Finally, click “Add New” and
the rule will be added to the mode. The device will transmit packets to Port 80 through WAN2. However,
with only the above rule, packets that do not go to Port 80 may be transmitted through WAN2; therefore,
a second rule is necessary. The second rule: Select “All Ports [TCP&UDP/1~65535]” from the
pull-down option list “Service”, and then input “192.168.1.2 ~ 254” in the boxes of “Source IP”. Retain
the original numbers “0.0.0.0” in the boxes of “Destination IP” (which means to include all Internet IP
addresses). Select WAN1 from the pull-down option list “Interface”, and then click “Enable”. Finally,
click “Add New” and the rule will be added to the mode. The device will transmit packets that are not
going to Port 80 to the Internet through WAN1.