User Manual

17
OPERATING INSTRUCTION
Data Hold Mode
To hold the present reading on the display, press the
" HOLD " key. The meter enters Data Hold mode, and the
symbol "
" appears on the display as an indicator.
To exit the Data Hold mode, press this key again. " "
disappears.
Measuring DC or AC Voltage
1. Set the rotary switch in the position.
2. If you want to measure DC voltage, press the "FUNC "
key until " " appears on the display.
If you want to measure AC voltage, press the "FUNC "
key until " " appears on the display.
3. Connect the test leads across the source or circuit to
be tested.
4. Read the reading on the display. For DC voltage
measurements, the polarity of the red lead connection
will be indicated as well.