User Manual

19
Measuring Resistance
1. Set the rotary switch in the
position.
2. Press the "FUNC " key until there are no symbols
" " and " " and capacitance measurement unit
on the display.
3. Connect the test leads across the resistor to be tested.
4. Wait until the reading is stable, then read the reading
on the display.
Note:
1. For measurements > 1M , the meter may take a few
seconds to stabilize reading. This is normal for high
resistance measurements.
2. When the test leads are open, " OL " will be displayed
as an overrange indication.
3. Before measurement, disconnect all power to the
circuit to be tested and discharge all capacitors
thoroughly.
Continuity Test
1. Set the rotary switch in the position.
2. Press the "FUNC " key until the symbol " "
appears on the display.
3. Connect the test leads across the circuit to be tested.