10/100 Base-TX to 100Base-FX Converter POE Powered Device Product Manual

1. Overview
The POE120 Series IEEE 802.3u compliant media converters support two
types of media 10/100 Base-TX and 100Base-FX. With LFP (Link Fault
Propagation) support it allows the administrator to easily diagnose link faults
on their network. If the Copper or Fibre link fails, the converter forces the link
status of the connecting device to also fail.
The POE120 Series media converters are fully compliant to the IEEE 802.3af
standard. The converters advanced auto-sensing algorithm allows the unit to
draw power from any IEEE 802.3af Power Sourcing Equipment (PSE) device
(POE100 Series Converter, or PoE Switch) or Power over Ethernet Injector. It
also supports high levels of safety support with short circuit protection and
power-in auto-detection. The POE120 series converters can be powered from
either a standard plug pack or a PSE device.
2. Model Description
Model Power Description
POE120 Series 60mA@-48VDC over Cat.5
100Mbps Fibre Transceiver Wavelength
ST/SC Multimode 2Km 1310nm
SC.S05/S20/S40/S60Km Single Mode 1310nm
SC.S80/S100Km Single Mode 1550nm
Single Fibre Model TX, RX Wavelength
TX (Transmit) 1310nm 1310nm Single Mode 20Km
RX (Receive) 1550nm
TX (Transmit) 1550nm 1550nm Single Mode 20Km
RX (Receive) 1310nm
Note:
The 1310nm and 1550nm models must be installed in pairs,
i.e., install 1310nm model at one end and the 1550nm model at the other end.
3. Checklist
Before you start installing the POE converter, please verify that the package
contains the following items.
- The POE120 Series Converter
- CD containing this manual
Please notify your sales representative if any of the above items are missing
or damaged.