Install guide

AMS Quick Install Guide
5
- Radio-frequency electromagnetic field according to IEC 61000-4-
3:2006+A1:2007+A2:2010
- Electrical fast trsnsient/burst according to IEC 61000-4-4:2010
- Surge immunity test according to IEC 61000-4-5:2005
- Immunity to conducted disturbances, Induced by radio-frequency
fields:IEC 61000-4-6:2008
- Power frequency magnetic field immunity test according to IEC
61000-4-8:2009
- Voltage dips, short interruptions and voltage variations immunity test
according to IEC 61000-4-11:2004
LVD: - EN60950-1:2006+A11:2009+A1:2010EMC:
Australian C-Tick Compliance.
This equipment is compliant with the required Australian C-Tick standards
PLEASE READ THE FOLLOWING SAFETY INFORMATION CAREFULLY BEFORE INSTALLING THE
SWITCH:
WARNING: Installation and removal of the unit must be carried out by qualified personnel only.
 This guide is intended for use by network administrators who are responsible for setting up
and installing network equipment; consequently it assumes a basic working knowledge of
LANs (Local Area Networks).
 The unit must be connected to an earthed (grounded) outlet to comply with international
safety standards.
 Do not connect unit to an A.C outlet (power supply) without an earth (ground) connection.
 The appliance coupler (the connector to the unit and not the wall plug) must have a
configuration for mating with an EN 60320/IEC 320 appliance inlet.
 The socket outlet must be near to the unit and easily accessible. You can only remove power
from the unit by disconnecting the power cord from the outlet.
 This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950.
The conditions are only maintained if the equipment to which it is connected also operates
under SELV conditions.