User manual

APS User Manual
171
1.2.11-2 Ports
This section is used to configure Port specific parameters for your VLAN’s. Here we can configure a
port as a Tagged (Trunk) or Untagged (Access) port or as a Hybrid port allowing both tagged and
untagged frames.
Web Interface
To configure the Port settings via the Web Interface:
1. Click Configuration, VLAN and Ports.
2. Configure the parameters required for all ports.
3. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Parameter Description
Ethertype for Custom S-Ports: This field specifies the ether type used for Custom S-ports. This is a
global setting for all the Custom S-ports. Custom Ethertype enables the user
to change the Ethertype value on a port to any value to support network
devices that do not use the standard 0x8100 Ethertype field value on
802.1Q-tagged or 802.1p-tagged frames.
Port: Physical port of the switch.
Fig. 76 VLAN Port Configuration